Code No.: Tranfusion-1
Consist of:
1. Piercing device--Made of medical grade white ABS, with or without
Air inlet, 3 or 4 holes size according to ISO1135-4 standard.
2. Protective cap--Made of PP or PE.
3. Drip chamber--Made of soft PVC, size according to ISO1135-4
Standards.
4. Fluid filter--Cylinder support is made of ABS or PE, nylon net,
Mesh size: 15 micron.
5. Air inlet--Cap is made of red, white, or blue PP
6. Water-repellent filter-PP support, hydrophobic filtering paper, made of
Acrylic resin and nylon.
7. Flow regulator--Made of PP or ABS, normal shape, small size or
Horned shape, large size.
8. Injection site--Latex cone, rubber cone, synthetic rubber cone, Y
Site--made of hard transparent PVC+injection site made of natural or
Synthetic rubber.
9. Soft tubing--Made of soft medical grade PVC, diameter 3x4mm,
150cm in length, or adjust according to requirements...
10. Terminal connector: Made of PE, PVC, luer lock or luer slip.
11. Components assembly: By gluing with solvent cyclohexanone

Specification:
They are suited to hard containers and soft bags( without air inlet type)
Sterile, non-toxic, pyrogen free, sterilized by EOG.